PRM2 direct operated pressure relief valve made as a modular version with mounting surface according to the ISO 4401 (CETOP RP 121H) standards.

It can be assembled with all ISO 4401-02 (CETOP R02) modular valves without the use of pipes, using suitable tie-rods or bolts. Available in versions for single relief on P or B with discharge in T, or two independent relief on A and B with discharge in T, all with three different pressure adjustment ranges.

This valve is normally used as a hydraulic circuit pressure limiting device or as a limiting device of the pressure peaks generated during the movement of hydraulic actuators.

It is supplied with a countersunk hex adjustment screw and locking nut.

MCD direct operated pressure relief valve made as a modular version with mounting surface according to the ISO 4401 (CETOP RP 121H) standards.

It can be assembled with all ISO 4401-03 (CETOP 03) modular valves without the use of pipes, using suitable tie-rods or bolts. Available in versions for single adjustment on one control line, or dual on two control lines and with four different pressure adjustment ranges.

This valve is normally used as a hydraulic circuit pressure limiting device or as a limiting device of the pressure peaks generated during the movement of hydraulic actuators.

It is normally supplied with a hexagonal head adjustment screw, locking nut, and limitation of the maximum adjustment travel.

MRQ pilot operated pressure relief valve made as a modular version with mounting surface according to ISO 4401 (CETOP RP 121H) standards.

It can be assembled with all ISO 4401-03 (CETOP 03) modular valves, without the use of pipes, using suitable tie-rods or bolts. Available in versions for single adjustment on one control line or dual on two control lines and with four different pressure adjustment ranges.

This valve is normally used as a hydraulic circuit pressure limiting device. Supplied with a hexagonal head adjustment screw, locking nut, and limitation of the maximum adjustment travel.

The valve PBM3 is a directly operated three-way pressure regulator, developed as a modular version with mounting surface according to the ISO 4401 (CETOP RP121H) standards.

It aims to adjust the output backpressure coming from the actuator, to allow the input free flow. Normally used on vertically mounted cylinders, where the cancellation of a load weighting on the road of the same cylinder is needed.

PRM5 pilot operated pressure relief valve made as a modular version with mounting surface according to ISO 4401 (CETOP RP121H) standards.

It can be assembled with all ISO 4401-05 modular valves without the use of pipes, using suitable tie-rods or bolts.

Versions are available for single adjustment on one control line, or dual on two control lines and with four different pressure adjustment ranges.

This valve is used as a hydraulic circuit pressure limiting device.

It is supplied with a hexagonal head adjustment screw and locking nut. It is also available with a knob.